TX1320 M4 Upgrade and Maintenance Manual 93
Basic software procedures
Ê The Network Interfaces (Summary) overview shows all configured LAN
teams and their components. Choose a LAN team to display further details:
– LAN Team Properties: Properties of the selected LAN team
– LAN Team Statistics: Available statistics about the selected LAN team
I For more information, see the "ServerView Operations Manager - Server
Management" user guide.
5.2.18.1 After replacing/upgrading LAN controllers
Ê You need to restore the configuration for the LAN Teaming, using the LAN
driver utility or OS teaming software.
Ensure that the controllers have been assigned as primary or secondary
according to your requirements.
I For more information, see the relevant LAN driver manual.
5.2.18.2 After replacing a system board
I The following procedure must be done for each system board that is
replaced.
Ê Confirm with the customer whether the onboard LAN controller you have
replaced has been used as part of a LAN teaming configuration.
Ê If LAN teaming has been active, you will need to restore the configuration
using the LAN driver utility or OS teaming software.
I For more information, see the relevant LAN driver manual.
5.2.19 Switching off the ID indicator
Press the ID button on the front panel, or use the iRMC web interface or
ServerView Operations Manager to switch off the ID indicator after the
maintenance task has been concluded successfully.
I For more information, see section "Locating the defective server" on
page 47 or the "ServerView Suite Local Service Concept (LSC)" and
"iRMC S5 - Web Interface" user guides.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
