Fujitsu PRIMERGY TX1320 M4 - Environmental and hardware errors

TX1320 M4 Upgrade and Maintenance Manual 89
Basic software procedures
Checking the label
Ê If available, check the label on the controller.
Beside the part number, you may find the MAC address.
Using an UEFI BIOS
Ê Enter the BIOS setup menu.
Ê Select the Advanced menu.
The addresses are displayed at the Advanced menu main page.
I Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
LAN controller always provide the MAC addresses.
Using the iRMC web interface
Ê Log into the ServerView iRMC web interface.
Ê Open the System menu.
Ê Open the Network page.
Ê In the Ethernet Ports group, you will find detailed information on each
network controller in the managed PRIMERGY server, including its MAC
address.
I This information is only available with the iRMC S5 or above.
Only network controllers supporting the Command Line Protocol
(CLP) will be displayed.
I For add-in cards the vendors provide documentation and tools, offered
on the Fujitsu support web pages:
http://ts.fujitsu.com/support/
Select the server, select Downloads - More Details - Driver.
Some vendors bundle the documentation together with the driver
package.
5.2.16.2 Looking for the WWN address of a fibre channel controller
There are several possible locations where these addresses can be found.
Ê Inform the customer about the new or changed WWN address.