Fujitsu PRIMERGY TX1320 M4 - Replacing a Front USB Connector; Preliminary Steps; Removing the Front USB Connector; Installing the New Front USB Connector

270 Upgrade and Maintenance Manual TX1320 M4
Front panel
13.2.3 Replacing a front USB connector
13.2.3.1 Preliminary steps
Ê "Locating the defective server" on page 47
Ê "Shutting down the server" on page 49
Ê "Disconnecting the power cord" on page 50
Ê "Getting access to the component" on page 51
13.2.3.2 Removing the front USB connector
Ê Disconnect the cable end of the front USB connector, see section
"Disconnecting the front USB connector" on page 268.
Ê Remove the front USB connector, see section "Removing the front USB
connector from FBU tray" on page 269.
13.2.3.3 Installing the new front USB connector
Ê Install the front USB connector, see section "Installing the front USB
connector" on page 266.
Ê Connect the front USB connector, see section "Connecting the front USB
connector" on page 267.
13.2.3.4 Concluding steps
Ê "Reassembling" on page 57
Ê "Connecting the power cord" on page 60
Ê "Switching on the server" on page 63
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver