TX1320 M4 Upgrade and Maintenance Manual 311
System board and components
Ê As soon as the startup screen appears, press the [F2] function
key to enter the BIOS.
If a password is assigned, enter the password and press [Enter].
Ê Select the Save & Exit menu.
Ê Select Save Changes and Exit or Save Changes and Reset.
Ê Verify that the Global Error indicator stops flashing.
Ê "Verifying the system time settings" on page 83
Ê "Updating or recovering the BIOS and the iRMC S5" on page 71
Ê If applicable, activate TPM functionality in the system BIOS under Security
> TPM (Security Chip) Setting > Security Chip. For more information, see
the corresponding BIOS Setup Utility reference manual.
Ê "Verifying system information backup/restore" on page 72
Ê "Looking for MAC/WWN/GUID and SAS addresses" on page 88
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 86
Ê "Resuming BitLocker functionality" on page 87
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 306.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing a system board" on page 93.
To Next Page
Loading...
