Installing the SAS expander board
▶
Install the SAS expander board, see "Installing the SAS expander board" on
page 306.
Concluding steps
▶
Install the fan bridge, see "Handling the fan bridge" on page
92.
▶
"Installing the system air duct" on page
68.
▶
Install HDD/SSD modules or HDD/SSD dummy modules into all HDD bays,
see "Installing 2.5-inch HDD/SSD modules" on page 218 and "Installing a
2.5-inch HDD/SSD dummy module" on page 222.
For more information on HDD mounting order, see "2.5-inch HDD/
SSD configurations" on page 202.
▶
"Reassembling" on page 68.
▶
"Connecting the power cord" on page 82.
▶
"Switching on the server" on page 83.
▶
Update the system information of your server using the Chassis ID Prom
Tool, see "Using the Chassis ID Prom Tool" on page 136. Select the
corresponding system name depending of an SAS expander board is
installed or not.
▶
"Resuming BitLocker functionality" on page 130.
Hard disk drive (HDD) / solid state disk (SSD)
264 Upgrade and Maintenance Manual TX2550 M5
To Next Page
Loading...
