Figure 217: Installing the OCP module (B)
▶
Install the OCP carrier in the OCP module slot.
Concluding steps
▶
If applicable, install the riser module, see "Installing the riser module" on
page 87.
▶
"Reassembling" on page
68.
▶
"Connecting the power cord" on page
82.
▶
"Switching on the server" on page 83.
▶
Configure the new MAC address in the OS, if you have no VIOM
(ServerView Virtual-IO Manager) installed. If you have VIOM installed, it is
not necessary to configure the MAC address. This is virtualized by VIOM.
▶
Inform the customer about new MAC addresses. For more information, see
"Looking for MAC/WWN/GUID and SAS addresses" on page 132.
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 129.
▶
"Configuring LAN teaming" on page 138.
Expansion cards and backup units
TX2550 M5 Upgrade and Maintenance Manual 341
To Next Page
Loading...
