GE Mark VIeS - Wiring and Configuration; Wiring and Configuration for New Installs

7.3.3 Wiring and Configuration
For available modes and wiring and configuration instructions for new installations, refer to the table in the section Wiring
and Configuration for New Installs.
For wiring and configuration instructions for retrofit installations related to the existing terminal board being replaced by the
SUAA, refer to the following sections:
• Wiring and Configuration for STAI/SHRA Retrofits
• Wiring and Configuration for STAO Retrofits
• Wiring and Configuration for STTC Retrofits
• Wiring and Configuration for SRTD Retrofits
• Wiring and Configuration for 24 V STCI Retrofits
7.3.3.1 Wiring and Configuration for New Installs
The following table provides a complete list of available Analog modes with links to the appropriate wiring and configuration
instructions.
Mode Field Device
Wiring Diagrams ToolboxST Configuration
CurrentInput
(with HART option)
4–20 mA Input
Internally and externally
powered
Analog Inputs
Current Inputs
VoltageInput
± 5 V or ± 10 V input
internally and externally
powered
Voltage Inputs
CurrentOutput
(with HART option)
0–20 mA Output Current Outputs Current Outputs
RTD
RTD types RTD Inputs
RTDs
Thermocouple
TC types
Local or Remote CJs
Thermocouple Inputs Thermocouples
DigitalInput
External switches
Digital Inputs Digital Inputs
Refer the section SUAA Universal Analog Terminal Board for more information, including a diagram and complete terminal
board screw definitions.
YUAA Universal I/O Modules GEH-6855_Vol_II System Guide 179
Public Information