GE Mark VIeS - Firmware Error - Internal Process Crashed; Platform Hardware Does Not Match Configuration

280
Description Platform hardware does not match configuration
Possible Cause
• During commissioning/maintenance: Platform type identified in the application configuration does not match actual
hardware
• During normal operation: Hardware failure
Solution
• Fix the platform type in the ToolboxST application. From the General tab, select General Properties and Platform.
• Rebuild and download the application.
• If problem persists, replace the controller.
282
Description Firmware Load Error - application independent processes failed to initialize
Possible Cause Runtime malfunction. An application-independent firmware process could not be started successfully.
Solution
• Reload firmware and application and restart.
• If controller is a UCSA, try formatting and reloading the flash memory.
• If I/O pack has diagnostic: try to re-download the base load.
• Replace the controller or I/O module.
283
Description Firmware error - Internal process crashed
Possible Cause Runtime or hardware malfunction (runtime process failed).
Solution
• Reload firmware and application and restart.
• If controller is a UCSA, try formatting and reloading the flash memory.
• If this does not work, replace the controller.
46 GEH-6855_Vol_II GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Public Information