GE Mark VIeS - JPDG Fuse FU12;FU13 (JFB Connector) Is Blown; JPDG Fuse FU14;FU15 (JFC Connector) Is Blown; JPDG Fuse FU16;FU17 (JFD Connector) Is Blown; JPDG Fuse FU18;FU19 (JFE Connector) Is Blown

213
Description JPDG fuse FU12/FU13 (JFB connector) is blown.
Possible Cause The FU12 or FU13 fuse is blown.
Solution
• Replace the fuse.
• If the 24/48 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_24VFdbkMag) to Disabled.
214
Description JPDG fuse FU14/FU15 (JFC connector) is blown.
Possible Cause The FU14 or FU15 fuse is blown.
Solution
• Replace the fuse.
• If the 24/48 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_24VFdbkMag) to Disabled.
215
Description JPDG fuse FU16/FU17 (JFD connector) is blown.
Possible Cause The FU16 or FU17 fuse is blown.
Solution
• Replace the fuse.
• If the 24/48 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_24VFdbkMag) to Disabled.
216
Description JPDG fuse FU18/FU19 (JFE connector) is blown.
Possible Cause The FU18 or FU19 fuse is blown.
Solution
• Replace the fuse.
• If the 24/48 V dc input is not used, this diagnostic alarm can be disabled by setting the InputDiagEnab parameter on the
associated input (DC_24VFdbkMag) to Disabled.
360 GEH-6855_Vol_II GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Public Information