GE Mark VIeS - Auto-Reconfiguration Server Failed Scanning or Downloading an I;O Pack; Auto-Reconfiguration Server Installation Is Incomplete; Could Not Configure Consumed Exchanges from One or more Producers

486
Description Auto-Reconfiguration server installation is incomplete
Possible Cause
• A download from the ToolboxST application to an I/O pack and/or the Auto-Reconfiguration server has failed
• Not all of the I/O packs were selected for download
Solution Perform a scan and download using the ToolboxST application.
487
Description Auto-Reconfiguration server failed scanning or downloading an I/O pack
Possible Cause At least one I/O pack is in an unexpected state that the Auto-Reconfiguration server is unable to handle
Solution
• Cycle power on the I/O pack.
• Perform a scan and download using the ToolboxST application.
• Replace the I/O pack.
488
Description EGD Error - Could not configure consumed exchanges from one or more Producers
Possible Cause
• Producer EGD Page(s) configured incorrectly
• Producer(s) powered down
• Network connectivity intermittent or severed
• Internal Firmware failure
Solution
• Rectify configuration error. Compress all pages and download application to Producer.
• Ensure each Producer is powered on and in the Controlling state.
• Refer to the Network Troubleshooting guide for possible solutions.
• Replace the Consumer and/or Producer hardware.
Controllers GEH-6855_Vol_II System Guide 61
Public Information