30
Description Firmware/Configuration Incompatibility Error;Firmware: [ ] Config: [ ]
Possible Cause I/O pack or module configuration files are incompatible with the firmware. Files have wrong revision.
Solution
• Confirm the correct installation of the ToolboxST application.
• Verify that each I/O pack or module is upgraded to the latest version by right-clicking each I/O pack or module and
selecting Upgrade.
• Rebuild the application and download the firmware and the application code to the affected I/O pack or module.
31
Note This alarm is obsolete.
Description Firmware/IO Configuration Incompatibile;Firmware: [ ] IO Config: [ ]
Possible Cause
• I/O pack or module configuration files are incompatible with the firmware.
• The files have the wrong revision.
Solution
• Confirm the correct installation of the ToolboxST application.
• Verify that each I/O pack or module is upgraded to the latest version by right-clicking each I/O module and selecting
Upgrade.
• Rebuild the application, and download the firmware and application code to the affected I/O pack or module.
256
Description [ ]V Pwr supply voltage is low
Possible Cause Input voltage dropped below 18 V. I/O pack or module input power is required to be within range 28 V
±5%. I/O pack or module operation will be compromised or may stop completely.
Solution
• If PPDA is available to monitor control cabinet power, check the I/O pack or module for active alarms.
• Check the I/O pack or module power within the control cabinet; begin with power supplies and work toward the affected
I/O pack or module.
450 GEH-6855_Vol_II GEH-6855_Vol_II Mark VIeS Functional Safety Systems Volume II
Public Information
To Next Page
Loading...
