GE Mark VIeS - Page 329

80,83
Description JPDM-[ ] fuse FU10 (J3 connector) is blown
Possible Cause
• The specified fuse is blown.
• The 28 V T power supply input is not connected.
Solution
• Replace the fuse.
• Verify the power supply connections to the terminal board.
81,84
Description JPDM-[ ] fuse FU11 (J3 connector) is blown
Possible Cause
• The specified fuse is blown.
• The 28 V T power supply input is not connected.
Solution
• Replace the fuse.
• Verify the power supply connections to the terminal board.
82,85
Description JPDM-[ ] fuse FU12 (J3 connector) is blown
Possible Cause
• The specified fuse is blown.
• The 28 V T power supply input is not connected.
Solution
• Replace the fuse.
• Verify the power supply connections to the terminal board.
PDM Power Distribution Modules GEH-6855_Vol_II System Guide 329
Public Information