2. Disconnect the cartridge connector by pressing the tabs on each side of it and pulling it gently away
from the cartridge.
3. R
emove the empty cartridge from the printer.
NOTE: Some residual ink can be expected in the cartridge, ranging from 2% to 5% of the original
content.
Insert an ink cartridge
NOTE: The ink car
tridge is supplied in an insulating bag; do not open it until you are ready to use the
cartridge.
1. Check th
at the new cartridge is of the correct color.
2. Place the cartridge on a at surface and turn it four times (rotating it through 360 degrees) as indicated
on the label, to ensure that the ink is well mixed before use.
3. T
ear o the square and fold it inside the handle as illustrated.
4. Put the new cartridge into its correct place on the printer.
TIP: Use both hands: the cartridge is quite heavy.
5. Check th
at the rubber part around the needle in the cartridge connector is clean. Clean gently if
necessary.
114 Chapter 5 Handle the ink system ENWW
To Next Page
Loading...
