3. Remove the input spindle.
4. Remove the output spindle (1), carry it around to the input side with the same orientation (2) and install
it into the input position (3). Maintain the same orientation: Left edge always on the left, as indicated
below with the colors blue and red.
5. When completed, click Done in the IPS window to conrm.
Side B: Load and print
1. Load roll-to-roll conguration: see Load a roll (roll-to-roll conguration) on page 54.
NOTE: By default the left edge of the substrate is detected to minimize registration errors along the
scan axis when printing double-sided. When printing on translucent substrates or types of substrate
with irregular edges you can disable this option by clicking Substrate Edge Detection.
2. Align the registration line with the beginning of the platen.
●
If Side B: Calibration space was selected, align the dotted line.
ENWW Double-sided printing 75
To Next Page
Loading...
Need help?
General
