NOTE: Neither the dual-roll spindle nor the ink collector kit can be used while printing double-sided
jobs.
2. Dene side A preferences (see Double-sided on page 100) and select the Print button.
3. Before unloading the substrate, select the Substrate load/unload button in the IPS, select How to
unload side A, and follow the on-screen instructions.
NOTE: Jobs must be dened for double-sided printing, side A and side B, this information is available
while a job is printing in Print Properties.
NOTE: Selecting the check boxes Side B: loading space and Side B: Calibration space is highly
recommended, see Dene double-sided job on page 100.
Side A: Unload
1. Cut the substrate close to the input roll.
2. Collect the substrate onto the output spindle. Check the substrate is collecting correctly on to the
spindle to avoid telescoping.
74 Chapter 3 Handle the substrate ENWW
To Next Page
Loading...
