CAUTION: Proper maintenance and genuine HP consumables are required to ensure that the printer
operates safely as designed. The use of non-HP consumables (foams, îžlters, printhead cleaner roll, or inks)
may present a risk of îžre.
CAUTION: Do not load substrates with auto-ignition temperatures below 250°C (482°F). Ensure that no
ignition sources are close to the substrate.
NOTE: Test method based on EN ISO 6942:2002: Evaluation of materials and material assemblies when
exposed to a source of radiant heat, method B. The test conditions, to determine the temperature when the
substrate starts ignition (either ame or glow) are: Heat ux density: 30 kW/m², copper calorimeter, K type
thermocouple.
IMPORTANT: Do not use the Ink Collector Kit when in-line slitters are installed, as the cutting position can
damage the protector of the Kit. It is recommended to uninstall the in-line slitters when working with the ink
collector.
The above image is a QR code containing a link to a video; see Documentation on page 2.
Kit components
1. Ink-collector container
2. Six ink collectors with two replaceable foams
ENWW The ink collector kit 37