Load a roll onto the spindle
NOTE: Contact HP to know the recommended third party solutions for substrate lifter and core adaptors.
Single-roll printing
The spindle has a pneumatic connector at one end and a gear at the other.
1. Check that the gear is on the correct side.
2. Insert the spindle into the roll taking into consideration the winding direction.
TIP: The spindle is quite heavy in order to ensure stiîž«ness and so avoid skew and wrinkles, so two
people are recommended for this operation.
ENWW Load a roll onto the spindle 47
To Next Page
Loading...
Need help?
General
