NOTE: Test method based on EN ISO 6942:2002; Evaluation of materials and material assemblies
when exposed to a source of radiant heat, method B. The test conditions, to determine the temperature
when the substrate starts ignition (either ame or glow) were: Heat ux density: 30 kW/m2, Copper
calorimeter, K type thermocouple.
●
P
roper maintenance and genuine HP consumables are required to ensure that the printer operates
safely as designed. The use of non-HP consumables (foams, lters, printhead cleaner roll, and inks) may
pr
esent a risk of re.
LED's array supports, beam and enclosures can reach high temperatures. To avoid the risk of re, take the
following precautions:
●
Take special care with zones marked with warning labels.
●
Do not place objects covering the LED's arrays supports, beam and enclosures.
●
Take care not to spill liquid on the accessory. After cleaning, make sure all components are dry before
using the printer.
●
Do not attempt to modify LED's array supports, beam and enclosures.
Mechanical hazard
The printer has moving parts that could cause injury. To avoid personal injury, take the following precautions
when working close to the printer and (optional) in-line slitters.
●
Keep your clothing and all parts of your body away from the printer's moving parts.
●
Avoid wearing necklaces, bracelets and other hanging objects.
●
If your hair is long, try to secure it so that it will not fall into the printer.
●
Take care that sleeves or gloves do not get caught in the printer's moving parts.
●
Avoid standing close to the fans, which could cause injury and could also aect print quality (by
obstructing the air ow).
●
Do no
t touch gears or moving rolls during printing.
●
Do not operate the printer with covers bypassed.
●
Do not touch the in-line slitters during printing.
●
Handle the in-line slitters with care, and store them safely in their box when not used with the printer.
Light radiation hazard
Infrared (IR) radiation is emitted from the dryer module. The dryer enclosure limits radiation in compliance
with the requirements of the exempt group of IEC 62471:2006, Photobiological safety of lamps and lamp
systems. However, you are recommended not to look directly at the lamps while they are on. Do not modify
the dryer enclosure.
UV radiation can be emitted from the LED's array in compliance with the requirements of the exempt group of
IEC 62471:2006 Photobiological safety of lamps and lamp systems. However, you are recommended not to
look directly for a long time at the output LED's lights while they are on.
Alignment tool for Dual roll center support uses a Laser class > I in compliance with limits according to CE and
FDA requirements, and has its laser warning label accordingly. You are recommended not to look directly at
the laser beam.
ENWW Safety precautions 5