HP Latex 3000 Series

PP and PE lm and banner
●
Polypropylene (PP) lm
●
S
ynthetic paper (such as Yupo)
●
Tyvek
●
Coated PE/HDPE (polyethylene) banner
PET
lm
●
P
olyester (PET) backlit lm
●
Polyester (PET) frontlit lm
●
Polyester (PET) grey-back lm
Textile
P
orous textiles may be used only with the ink collector. To check the porosity of your substrate, see Check the
porosity of your substrate on page 26.
●
Polyester textile and fabric
●
Textile banner
●
Backdrops
●
Textile mesh with liner
●
Frontlit textile with liner if porous
●
Backlit textile with liner if porous
●
Canvas
●
Flag and voile with liner
●
Cotton textile
●
Self-adhesive textile
Wall covering
NOTE: This is an application example, not a selectable category.
●
P
aper wall covering or wallpaper
●
PVC wall covering
●
Pre-pasted wall covering
●
Non-woven wall covering
●
Textile wall covering
●
Self-adhesive wall covering
Check the porosity of your substrate
1. If the printer has any substrate loaded, unload it.
2. Cut a piece of self-adhesive vinyl white gloss 15 × 50 mm (0.6 × 2 in) in size.
26 Chapter 3 Handle the substrate ENWW