EasyManuals Logo

HP Latex 3000 Series User Manual

HP Latex 3000 Series
363 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #22 background imageLoading...
Page #22 background image
Carriage view
1. Optimizer printhead latch
2. Oiler foams
3. Printhead
4. Aerosol lters
5. Drying lters
6. Printhead latch
Printer software
Your printer requires the following software:
The HP Internal Print Server is provided with your printer and is already installed in the printer's built-in
computer. It displays printer alerts and a summary of printer status, manages print jobs, and must be
used to interact with the printer in various ways. See HP Internal Print Server on page 19.
The HP Print Care program is provided with your printer and is already installed in the printer's built-in
computer. It displays printer status and history in detail, and helps you to maintain the printer and solve
any problems that may arise. See HP Print Care on page 150.
A Raster Image Processor (RIP) should be run on a separate computer; it cannot be installed on the
printer's built-in computer. It is not provided with the printer and should be obtained separately. The
printer is JDF-enabled. If your RIP supports this interface, it can retrieve and display printer and job
status.
14 Chapter 1 Introduction ENWW

Table of Contents

Other manuals for HP Latex 3000 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Latex 3000 Series and is the answer not in the manual?

HP Latex 3000 Series Specifications

General IconGeneral
BrandHP
ModelLatex 3000 Series
CategoryPrinter
LanguageEnglish

Related product manuals