Dual roll split spindles printing issues
When printing with an HP Latex 3500 and its dual roll center support, the following issues could appear if
misalignment of the center support Split spindles occurs:
●
Wrinkles
●
Ink smears
●
Uneven performance between the two rolls
●
Telescoping due to Skew convergence
Check center support alignment to solve this issue
1. Install laser pointer onto the latch laser support provided, and place it on the ISM latch support.
2. Place the target on the latch at the IPS side of the printer.
3. Use the laser pointer to reach the target at the IPS side of the printer.
4. Take the center support and place it in the middle of the printer.
5. Install targets on the center support.
ENWW Dual roll split spindles printing issues 305
To Next Page
Loading...
