NOTE: If you are in an area (such as California) that regulates VOC cleaning and maintenance uids,
instead of isopropyl alcohol use a VOC-certied cleaner such as a properly diluted Simple Green All-
Purpose Cleaner.
Finish o cleaning the output platen
1. Push the curing assembly back to its working position.
2. Close the curing latches.
3. Put the spindle back in position.
4. Ensure that the cleaned parts are completely dry and all vapor has completely evaporated.
Clean the perforated plate
Risk of burns Crush hazard Risk of trapped
ngers Hazardous moving part Electric shock hazard
For more safety information, see
Safety precautions on page 2
The perforated plate is a drilled metallic sheet located in the curing assembly. Through its holes the curing
f
ans blow hot air onto the substrate.
Prepare to clean the perforated plate
1. Ensure that the printer is not printing.
2. Unload the substrate.
3. Turn o the printer in the correct way for maintenance operations: see
Turn the printer o on page 160.
4. W
ait for the curing modules to cool down (approx. 5 min).
5. Remove the spindle.
Pull out the curing assembly
1. Open the front door.
ENWW Clean the perforated plate 209
To Next Page
Loading...
