Risk of burns Crush hazard Risk of trapped ngers Hazardous moving
part
Light radiation hazard Electric shock hazard
For more safety information, see Safety precautions on page 2
Prepare to clean the carriage bottom
1. Ensure that you have the HP Latex 3000 Printer Cleaning Kit, provided with your printer.
NOTE: A steel scourer is not provided but will also be needed.
2. Ensure that the printer is not printing.
3. Unload the substrate.
4. Wait for the drying modules to cool down (about 10 min).
5. Ensure that all windows, covers, and doors are closed and remain in their original positions.
6. Move the printhead carriage to the service position.
7. Move the carriage beam to its highest position (this takes about 2 minutes).
8. Turn o the printer in the correct way for maintenance operations: see Turn the printer o on page 160.
9. Open the front door.
NOTE: For some operations, there is better access from the back of the printer. Open the loading table
too if you nd it useful.
168 Chapter 8 Hardware maintenance ENWW
To Next Page
Loading...
