3. Unscrew the three screws shown below in order to remove the drying module (the left module is shown).
4. Pull the drying module carefully out of the carriage and lay it gently on a table.
Drying lamps emitter—safety precautions
CAUTION: Disregard of the safety precautions or improper operation of the infrared emitter can lead to
injuries and material damage.
CAUTION: The IR heating device must be operated only by specialists or trained personnel.
The operator of the system must compile speciîžc operating instructions for the training of operating
personnel.
CAUTION: The safety and functional reliability of the IR heating device are guaranteed only in the event of
use of original accessories and spare parts from Heraeus Noblelight.
WARNING! After an emitter break, a dangerous voltage may be exposed to contact by the heating spiral.
CAUTION: The reector side must not be cleaned.
ENWW Clean the drying module quartz glass and air outlet 223
To Next Page
Loading...
Need help?
General
