Prepare to replace a curing fan and resistor module
1. Ensure that you have the Curing Heater and Fan Module Kit (CZ056-67054), which is included in the
Standard Uptime Kit (D4J02A).
2. Ensure that the printer is not printing.
3. Turn o the printer in the correct way for maintenance operations: see Turn the printer o on page 160.
4. Wait for the curing modules to cool down.
Replace a curing fan and resistor module
1. Open the front door.
2. U
se a at screwdriver to remove the screws of the curing module.
252 Chapter 8 Hardware maintenance ENWW
To Next Page
Loading...
