●
W
et print: The ink comes out of the curing module not perfectly dry, and in severe cases the ink can be
smudged by touching it.
Here are some tips for solving both problems:
●
Increase the curing temperature.
●
Increase the curing airow.
●
Increase the curing temperature and airow.
●
Decrease the ink density.
●
Reduce throughput.
●
Repeat the Add New Substrate procedure in case you had wrong settings in the substrate preset.
332 Chapter 10 Troubleshoot print-quality issues ENWW
To Next Page
Loading...
Need help?
General
