Each of the spindles has its own motor. The motors maintain tension on the substrate. Some vacuum is
applied at the level of the platen to keep the substrate at. The substrate is moved forwards by the drive
roller motor, on which there is a pinch mechanism to prevent the substrate from slipping.
Before loading a roll into the printer, you must have a roll loaded onto a spindle (the input roll) and an empty
core loaded onto another spindle (the output roll). See Load a roll onto the spindle on page 47.
NOTE: For the output roll, use a single empty core the same length as the input core. Do not place two or
more shorter cores on the same spindle, which could cause substrate-advance problems.
TIP: The spindle and a roll of substrate can be heavy. You are recommended to use a forklift or some other
equipment to move it into position; otherwise, lift one end into the printer, and then the other end.
1. Go to the Internal Print Server and select Substrate Load/Unload, then select the correct conîžguration.
2. In the Internal Print Server, choose from the list of substrate types the type that you have loaded.
3. If they are installed, remove the substrate edge holders from the print platen so that they do not get in
the way while loading the substrate.
CAUTION: Loading the substrate on top of the edge holders could severely damage the printheads and
carriage.
4. Bring the new roll on its spindle to the rear of the printer, with the geared end of the spindle on the left.
5. Rest the ends of the spindle on the platforms provided at the rear of the printer; plastic pads are
provided to absorb the impacts.
6. In the same way, load the spindle with the empty core into the front of the printer. In this case, the
geared end of the spindle should be on the right.
7. All substrates can be loaded with the manual loading procedure (below). However, you may îžnd it easier
to use the assisted loading procedure if your substrate is exible or wide.
Assisted loading
1. Open the front door.
ENWW Load a roll into the printer 55
To Next Page
Loading...
Need help?
General
