◦
The thickne
ss of the substrate plus 1.9 mm for substrates that do not wrinkle.
◦
The thickness of the substrate plus 2 to 3 mm for substrates that wrinkle.
You cannot exceed the maximum height permitted by the Internal Print Server.
TIP: T
ry to avoid wrinkling by using substrates that do not wrinkle, or by using a slower print mode
that will allow you to lower the drying and curing power.
●
The ink c
ollector install position is used only for installing the ink collector kit (see
The ink collector kit
on page 36); it is not used for printing.
To set the carriage beam position, go to the Internal Print Server and select the appropriate position from the
drop-down list.
WARNING! Keep away from the printer's moving parts until the carriage beam has reached its new position.
CAUTION: Do not change the carriage beam position while the printhead cleaning roll is out of place.
ENWW Set the carriage beam position 91
To Next Page
Loading...
