HPE FlexNetwork MSR Series Comware 5 Layer 2 - Wan Access Configuration Guide

64
Step Command Remarks
9. Set the type and code
scheme of calling or called
numbers in incoming or
outgoing ISDN calls.
isdn number-property
number-property [
calling
|
called
] [
in
|
out
]
Optional.
By default, the system selects
ISDN number type and code
scheme depending on upper layer
service. For more information,
see
Table 1
.
10. Set the called number of
ISDN interface to send in
overlap mode (in this mode,
the digits of each called
number will be sent
separately and the number
of the digits sent each time
can be set by the user).
isdn overlap-sending
[digits ]
Optional.
In full-sending mode, all the digits
of each called number will be
collected and sent at a time by
default.
Table 1 ISDN number types and code schemes
Protocol
Field (Bit) value
Definition
Type Code scheme
8 7 6 5 4 3 2 1
ANSI
0 0 0 User-specified
0 1 0 National network identification
0 1 1 International network identification
0 0 0 0 Unknown/user-specified
0 0 0 1 Carrier identification code
0 0 1 1
Data network identification code (ITU-T
Recommendation X.121)
AT&T
0 0 0 Unknown
0 0 1 International number
0 1 0 National number
1 0 0 Subscriber number
0 0 0 0 Unknown
0 0 0 1
ISDN/telephony numbering loan (Recommendation
E.164/E.163)
1 0 0 1 Private numbering plan

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English