93
Figure 82 Creating a wireless service
2. Configure 802.1X authentication:
After you create a wireless service, the wireless service configuration page appears.
a. In the Security Setup area, select Open-System from the Authentication Type list, select
the Cipher Suite option, select CCMP from the Cipher Suite list, and select WPA2 from
the Security IE list.
b. Select the Port Set option, and select userlogin-secure-ext from the Port Mode list.
c. Select system from the Mandatory Domain list.
d. Select EAP from the Authentication Method list.
e. Disable Handshake and Multicast Trigger (recommended).
f. Click Apply.
Figure 83 Configuring security settings
3. Enable the wireless service:
a. Select Interface Setup > Wireless > Access Service from the navigation tree.
b. On the page that appears, select the dot1x option, and click Enable.
4. (Optional.) Enable 802.11g radio. By default, the 802.11g radio is enabled.
Select Interface Setup > Wireless > Radio from the navigation tree to enter the Radio page.
Make sure 802.11g is enabled.
To Next Page
Loading...
Need help?
General
