309
# Create an MST region named example, map VLAN 10, VLAN 30, and VLAN 40 to MSTI 1,
MSTI 3, and MSTI 4, respectively, and configure the revision level of the MST region as 0.
Configure the MST region in the same way the MST region is configured on Router A.
# Enable MSTP globally:
a. From the navigation tree, select Advanced > MSTP > Global.
b. On the page that appears, select Enable from the Enable STP Globally list.
c. Select MSTP from the Mode list.
d. Click Apply to submit the settings.
Verifying the configurations
You can use the display stp brief command to display brief spanning tree information on each
device after the network converges.
# Display brief spanning tree information on Router A.
[RouterA] display stp brief
MSTID Port Role STP State Protection
0 Ethernet0/1 ALTE DISCARDING NONE
0 Ethernet0/2 DESI FORWARDING NONE
0 Ethernet0/3 ROOT FORWARDING NONE
1 Ethernet0/1 DESI FORWARDING NONE
1 Ethernet0/3 DESI FORWARDING NONE
3 Ethernet0/2 DESI FORWARDING NONE
3 Ethernet0/3 ROOT FORWARDING NONE
# Display brief spanning tree information on Router B.
[RouterB] display stp brief
MSTID Port Role STP State Protection
0 Ethernet0/1 DESI FORWARDING NONE
0 Ethernet0/2 DESI FORWARDING NONE
0 Ethernet0/3 DESI FORWARDING NONE
1 Ethernet0/2 DESI FORWARDING NONE
1 Ethernet0/3 ROOT FORWARDING NONE
3 Ethernet0/1 DESI FORWARDING NONE
3 Ethernet0/3 DESI FORWARDING NONE
# Display brief spanning tree information on Router C.
[RouterC] display stp brief
MSTID Port Role STP State Protection
0 Ethernet0/1 DESI FORWARDING NONE
0 Ethernet0/2 ROOT FORWARDING NONE
0 Ethernet0/3 DESI FORWARDING NONE
1 Ethernet0/1 ROOT FORWARDING NONE
1 Ethernet0/2 ALTE DISCARDING NONE
4 Ethernet0/3 DESI FORWARDING NONE
# Display brief spanning tree information on Router D.
[RouterD] display stp brief
MSTID Port Role STP State Protection
0 Ethernet0/1 ROOT FORWARDING NONE
0 Ethernet0/2 ALTE DISCARDING NONE
0 Ethernet0/3 ALTE DISCARDING NONE
3 Ethernet0/1 ROOT FORWARDING NONE
To Next Page
Loading...
Need help?
General
