37
Item Description
Website Address
Specify the Website address for providing Web services. It must start with
http://
and end with
/
, for example,
http://www.domain.com/web1/
.
The website address can be an IP address or a domain name. If you
specify a domain name, make sure you configure domain name resolution
on
Advanced
>
DNS Setup
>
DNS Configuration
.
Default Page
Specify the home page to be displayed after an SSL VPN user logs in. For
example,
index.htm
.
Website Matching Mode
Specify website matching patterns to determine which webpages a user
can access through the website specified in the
Website Address
field.
Website matching supports fuzzy match based on wildcard
*
. Use vertical
bars (|) to separate multiple matching patterns.
Assume that you have specified a website address in the
Website
Address
field. To allow access to specific webpages provided at the
website, for example, the webpages www.domain1.com,
www.domain2.com, www.domain2.org, and www.domain2.edu, you can
specify
www.domain1.com|www.domain2.*
as the matching patterns.
Enable page protection
Select this box to enable page protection.
With page protection enabled, a login user cannot capture screen shots,
save pages, or printing pages.
4. Set whether to enable single login:
To enable single login, select the box before the Single login field to expand the configuration
area (as shown in Figure 395), an
d the
n configure the single login parameters as described
in Table 166.
After you enable sin
gle login and configure single login parameters, when a user accesses the
resource through the SSL VPN service interface, the user is redirected to the specified website
if the user's username and password for accessing the website are the same as those for
logging in to the SSL VPN service interface.
5. Click Apply.
Figure 395 Configuring single login
To Next Page
Loading...
