HPE FlexNetwork MSR Series User Manual

31
Item Description
DNS2
To configure the global DNS server on the page you enter, select
Advanced
>
DNS Setup
>
DNS Configuration
. The global DNS server has priority over the
DNS servers of the interfaces. The DNS query is sent to the global DNS server
first. If the query fails, the DNS query is sent to the DNS server of the interface
until the query succeeds.
MAC Address
Specify the MAC address of the Ethernet interface in either of the two ways:
• Use the MAC address of the device—Use the default MAC address of
the Ethernet interface, which is displayed in the brackets.
• Use the customized MAC address—Assign a MAC address in the field to
the Ethernet interface.
Table 12 Configuration items (in PPPoE mode)
Item Description
WAN Interface Select the Ethernet interface to be configured.
Connect Mode: PPPoE
Select the
PPPoE
connect mode.
In PPPoE mode, a username and password is provided by the local Internet
Service Provider (ISP).When the device connects to the ISP server, the ISP
server initiates PPPoE authentication. When the device passes the
authentication, the ISP server will send the IP address, subnet mask, gateway
IP address, and DNS server IP address to the device.
User Name Enter the username for identity authentication.
Password
Display whether a password has been specified for identity authentication.
An empty field indicates that no password is configured.
New Password Specify or modify the password for identity authentication.
TCP-MSS Set the maximum TCP segment length of an interface.
MTU Set the MTU of an interface.
Online for all time
Select an idle timeout interval:
• Online for all time—The device is always online.
• Online according to the idle timeout value—The device disconnects
from the server if no data exchange occurs between it and the server within
the specified time. Then, it automatically establishes the connection upon
receiving a request for accessing the Internet from the LAN.
When
Online according to the Idle Timeout value
is enabled, specify an idle
timeout value.
Online according to the
Idle Timeout value
Idle timeout
MAC Address
Specify the MAC address of the Ethernet interface in either of the two ways:
• Use the MAC address of the device—Use the default MAC address of
the Ethernet interface, which is displayed in the brackets.
• Use the customized MAC address—Assign a MAC address in the field to
the Ethernet interface.

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English