HPE FlexNetwork MSR Series

279
Source IP address binding is supported on the Layer 3 Ethernet interface, GigabitEthernet interface,
or dialer interface.
For information about DHCP, see HPE FlexNetwork MSR Router Series Comware 5 Layer 3—IP
Services Configuration Guide.
Configuring source address binding
Select Voice Management > Call Connection > SIP Connection from the navigation tree, and
click the Session Properties tab to access the session properties configuration page, as shown
in Figure 664.
Figure 664
Source add
ress binding configuration page
Table 242 Configuration items
Item Description
Media Stream Binding
Mode
Configure media stream binding mode or disable media stream binding.
• None—Disable media stream binding.
• IPv4 Address Binding—Bind the media stream to a static IPv4 address.
• Interface Binding—Bind the media stream to an interface.
IPv4 Address Bound with
the Media Stream
If you select
IPv4 Address Binding
as the media stream binding mode, you
must enter the IPv4 address to be bound in this field.
Interface Bound with the
Media Stream
If you select
Interface Binding
as the media stream binding mode, you must
specify the interface to be bound from the list. Only the Layer 3 Ethernet
interface, GE interface, and dialer interface are supported.
Signaling Stream
Binding Mode
Configure the signaling stream binding mode or disable signaling stream
binding.
• None—Disable signaling stream binding.
• IPv4 Address Binding—Bind the signaling stream to an IPv4 address.
• Interface Binding—Bind the signaling stream to an interface.
IPv4 Address Bound with
the Signaling Stream
If you select
IPv4 Address Binding
as the signaling stream binding mode, you
must enter the IPv4 address to be bound in this field.
Interface Bound with the
Signaling Stream
If you select
Interface Binding
as the signaling stream binding mode, you must
specify the interface to be bound from the list. Only Layer 3 Ethernet interfaces,
GE interfaces, and dialer interfaces are supported.