HPE FlexNetwork MSR Series User Manual

354
Item Description
Signal Type
Specify the signal type. Types 1, 2, 3, and 5 are the four signal
types (that is, types I, II, III, and V) of the analog E&M subscriber
line.
When you configure the signal type, make sure the signal type is
the same as that of the peer device.
The configuration will be applied to all analog E&M lines in the
corresponding slot.
Max Interval for Dialing the Next Digit
Specify the maximum interval for the user to dial the next digit.
This timer will restart each time the user dials a digit and will work
in this way until all the digits of the number are dialed. If the timer
expires before the dialing is completed, the user will be prompted
to hook up and the call is terminated.
Max Duration the System Waits for the
First Digit
Specify the maximum duration for the system to wait for the first
digit of a number.
Max Duration of Playing Ringback
Tones
Specify the maximum duration in seconds of playing ringback
tones.
Status
• Enable.
• Disable.
Advanced Settings
Start
Mode
Immediate
Start
Delay Time
before the
Calling Party
Sends DTMF
Signals in
Immediate Start
Mode
Specify the delay time before the calling party sends DTMF
signals in the immediate start mode.
Delay
Start
Delay Signal
Duration in Delay
Start Mode
Specify the delay signal duration in the delay start mode.
Delay Time
before the Called
Party Sends a
Delay Signal in
Delay Start Mode
Specify the delay time from when the called party detects a
seizure signal to when it sends a delay signal in the delay start
mode.
Wink Start
Delay Time
before the Called
Party Sends a
Wink Signal in
Wink Start Mode
Specify the delay time from when the called party receives a
seizure signal to when it sends a wink signal in the wink start
mode.
Duration of a
Wink Signal
Send by the
Called Party in
Wink Start Mode
Specify the time duration the called party sends wink signals in
the wink start mode.
Max Time the
Calling Party
Waits for a Wink
Signal in Wink
Start Mode
Specify the maximum amount of time the calling party waits for a
wink signal after sending a seizure signal in the wink start mode.
Input Gain on the Voice Interface
When the voice signals on the
line attenuate to a relatively
great extent, increase the voice
input gain value.
IMPORTANT:
Gain adjustment might lead to
call failures. Hewlett Packard

HPE FlexNetwork MSR Series Specifications

General

Brand	HPE
Model	FlexNetwork MSR Series
Category	Network Router
Language	English