3. Operation of CON Related Controllers
103
[Change Parameter Edit Password]
Change the parameter edit password.
Touch [Parameter edit password change].
If the system password is not “0000,” the password entry screen appears.
Input a system password.
Touch [ENT].
Enter the new parameter edit password to change to.
If the parameter edit password is not set, enter “0000.”
Touch [ENT].
Touch [Change].
The new password after change will be displayed. Make
sure it shows the same as the password you have set.
Touch [OK].
The default system password is “5119.”
For how to change the system password, refer to [Change
System Password] in the next page.
To Next Page
Loading...