COMBI P0: Play KARMA
137
KARMA
0–8h:KARMA
Selected parameter information
This status line shows detailed, read-only information about
the currently selected KARMA parameter.
Selected Switch/Slider [SW1...8, SL1...8]
Control Timbre Category Name
Realtime Control Name
For more information, please see “Select KARMA Module
Info:” on page 125.
Module Control
Module (Module Control) [M, A, B, C, D]
When used to control KARMA, the Control Surface sliders
and switches are five layers deep: one for each Module (A–
D), and a Master Layer capable of controlling selected
parameters from all of the Modules at once. Each layer has
its own Slider, Switch, and Scene settings.
The Module Control radio buttons (and the front-panel
MODULE CONTROL switch) let you switch between these
five layers.
To select a different layer, just press its on-screen radio
button, or use the front-panel MODULE CONTROL switch
to step through each layer in turn. When you do so, all of the
KARMA Sliders, Switches and Scenes will update instantly
to show their current values and names within the selected
layer.
KARMA Scenes 1–8
KARMA Scenes [1…8]
A KARMA SCENE includes the settings for all of the
KARMA Sliders and Switches. Each Combi can contain up
to eight Scenes.
To select a Scene, just press its switch - you’ll see all of the
KARMA Sliders and Switches update instantly to their new
values.
KARMA Switches 1–8
KARMA Switch [Off, On]
These switches control KARMA Performance or GE
(Generated Effect) Real-Time Parameters, as assigned on the
KARMA Perf RTP and GE RTP pages.
The switches indicate the current on/off status.
The parameters assigned to the switches and their on/off
status can be edited in the GE RTP page or the KARMA Perf
RTP page.
KARMA Sliders 1–8
KARMA Slider [000…127]
These sliders control KARMA Performance or GE Real-Time
Parameters, as assigned on the KARMA Perf RTP and GE
RTP pages.
The current values are shown under the sliders. The
parameters assigned to the sliders and their value can be
edited in the GE RTP page or the KARMA Perf RTP page.
▼0–9: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy from Program ☞p.185
• 4: Copy X–Y Motion ☞p.107
• 5: Copy Tone Adjust ☞p.111 (only in “Tone Adjust”)
• 6: Reset Tone Adjust ☞p.111 (only in “Tone Adjust”)
• 5: Copy Scene ☞p.115 (only in “KARMA”)
• 6: Swap Scene ☞p.115 (only in “KARMA”)
For more information, please see “Combination: Menu
Command” on page 185.
0–8h
0–8
Menu
To Next Page
Loading...
Need help?
General
