Korg M3 - 3-3: Osc T01-08, 3-4: Osc T09-16

SEQ P3: Track Param (Track Parameters) 3–3: OSC T01–08, 3–4: OSC T09–16
227
• 10: GM Initialize ☞p.273
• 11: Copy From Combi (Copy from
Combination) ☞p.273
• 12: Copy from Program ☞p.273
For more information, please see “Sequencer: Menu
Command” on page 271.
3–3: OSC T01–08,
3–4: OSC T09–16
These parameters specify how each MIDI track will be
sounded.
3–3(4)a: Location, Meter, Tempo, Tempo
Mode, Song Select, Track Select,
Reso, RPPR
3–3(4)b:Track Info
For more information, please see “0–1–1(2)a: Location,
Meter, Tempo, Tempo Mode, Song Select, Track Select, Reso,
RPPR” on page 195.
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 224.
3–3(4)c: OSC
Track 01 (Track Number):
Force OSC Mode [PRG, Poly, MN, LGT]
This lets you override the Program’s stored Voice Assign
Mode settings, if desired.
PRG: The Program’s stored Prog P1: Basic/DT/Ctrls–
Program Basic Voice Assign Mode settings will be used.
Poly: The track will play polyphonically, regardless of the
Program’s settings.
MN (Mono): The track will play monophonically, regardless
of the Program’s settings.
LGT (Legato): The track program will sound
monophonically, and will play legato according to the
Program’s Mode setting (Prog 1–1b).
With the MN or LGT settings, the Program’s Priority setting
(Prog 1–1b) will determine the priority of the note that
sounds when you play two or more notes.
OSC Select [BTH, OS1, OS2]
Specifies whether the MIDI track’s program will play OSC1,
OSC2, or both.
For EDS programs whose Oscillator Mode (Prog 1–1a) is
Double, this setting lets you specify that only OSC1 or OSC2
will sound.
BTH (Both): OSC1 and 2 will sound as specified by the
settings of the program.
OS1: Only OSC1 will sound.
OS2: Only OSC2 will sound. PCM programs will not sound
if Oscillator Mode is set to Single or Drums.
3–3c
3–3a
3–3b
3–3
Menu