SEQ P7–2: KARMA 2 7–2–5: Trigger A
251
7–2–5: Trigger A
Specifies the trigger conditions and latch on/off for the GE
that is selected for KARMA Module A.
7–2–5a: Module Parameter-Trigger
Control:
Quantize Trigger [Off, On]
Update On Release [Off, On]
For more information, please see “Control:” on page 84.
Delay:
Delay Start [Off, Fixed, 64T …4x1]
Delay Start Fixed [0000ms…5000ms]
For more information, please see “Delay:” on page 88.
Note (Trigger/Latch):
Note Trigger [Any, AKR, 1st, Dyn]
Note Latch [Off, On]
Note: In Sequencer mode, this can be turned on/off for each
KARMA Module. A KARMA Module for which this is On
(checked) will be in a Latch On condition when the LATCH
switch is on (LED lit).
For more information, please see “Note (Trigger/Latch):” on
page 88.
Envelope (Trigger/Latch):
Envelope1, Envelope2, Envelope3:
Envelope Trigger [Any, AKR, 1st, Dyn]
Envelope Latch [Off, Sus1, Rel1, Sus2, Rel2]
For more information, please see “Envelope (Trigger/
Latch):” on page 89.
Module Trigger:
Trigger By Module [Off, A, B, C, D]
GE Phrase Length [000…100%]
Cutoff Module A, B, C, D [Off, On]
For more information, please see “Module Trigger:” on
page 170.
▼7–2–5: Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: Copy from Program ☞p.185
For more information, please see “Sequencer: Menu
Command” on page 271.
7–2–6: Trigger B,
7–2–7: Trigger C,
7–2–8: Trigger D
In these pages you can set the trigger parameters for
KARMA modules B, C, and D.
For more information, please see “7–2–5: Trigger A,” above.
7–2
–5a
7–2
–5
Menu
To Next Page
Loading...
