COMBI P7–2: KARMA 2 7–2–1: Control A
169
COMBI P7–2: KARMA 2
7–2–1: Control A
Here you can set KARMA Module Control parameters. In
Combination mode, four KARMA Module A can be used.
7–2–1a: Module Parameter-Control
Control:
Transpose [–36…+36]
Root Position [Off, On]
Force Range
[Off, Lowest, Highest, C3-B3[1], C3-B3[2]]
Force Range Wrap [C…B]
For more information, please see “Control:” on page 84.
Timbre Zone Bypass [Off, On]
Specifies whether the key zone settings and velocity zone
settings (Combi 7–1–1b) of the timbre will be applied to the
phrase or pattern generated by the KARMA Module.
On (checked): The key zone settings and velocity zone
settings of the timbre will be bypassed for the phrase or
pattern generated by the KARMA Module. The settings of
the timbre will be ignored, and the notes generated by the
KARMA Module will be sounded.
Off (unchecked): The key zone settings and velocity zone
settings of the timbre will be applied to the phrase or pattern
generated by the KARMA Module. Notes generated by the
KARMA Module will not be sounded if they are outside the
key zone or velocity zone of the timbre.
Clock Advance:
Mode [Auto, Dyn, Auto+Dyn1, Auto+Dyn2]
Chord Trigger Mode
[Off, 1st, Chord1, Chord2, Chord3]
Size [
3, 3, , 3, , , 3, , , 3, , Event]
Velocity Sense Bottom [001…127]
For more information, please see “Clock Advance:” on
page 85.
Note Map:
Mode (Note Map Mode)
[Off, On-Main, On-Repeat, On-All]
Table (Note Map Table)
[Custom, Gtable 1…Gtable 64]
Transpose (Note Map Transpose) [–12…+12]
Chord Track (Note Map Chord Track) [Off, On]
Keyboard Track (C2 Ref)
(Note Map Keyboard Track) [Off, On]
Note Map Table Display
For more information, please see “Note Map:” on page 86.
▼7–2–1: Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: Copy from Program ☞p.185
For more information, please see “Combination: Menu
Command” on page 185.
7–2–2: Control B,
7–2–3: Control C,
7–2–4: Control D
In these pages you can set the parameters (controls) for
KARMA modules B, C, and D.
For more information, please see “7–2–1: Control A,” above.
7–2
–1a
7–2
–1
Menu
To Next Page
Loading...
Need help?
General
