Korg M3 - 7-4-4: Name Map A, 7-4-5: Name Map B, 7-4-6: Name Map C, 7-4-7: Name Map D; 7-4-8: Note Map

Sequencer mode
256
7–4–4: Name Map A,
7–4–5: Name Map B,
7–4–6: Name Map C,
7–4–7: Name Map D
Here you can select and edit the names of the KARMA
Sliders and Switches for modules A, B, C, and D.
For more information, please see “7–4–3: Names Master,”
above.
7–4–8: Note Map
Edit the Custom Note Map Table stored with the Sequence.
7–4–8a: Note Map (Custom)
Table [Custom, Global 1...64]
In (Note In) [C–1…G9]
Out (Note Out) [Remove, C–1…G9]
Table Grid
Octave Replicate [Off, On]
Reset
For more information, please see “7–2–8a: Note Map” on
page 97.
▼7–4–8: Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: Copy from Program ☞p.185
For more information, please see “Sequencer: Menu
Command” on page 271.
7–4
–8a
7–4
–8
Menu