M3 and MIDI CCs Parameters controlled by MIDI CCs #70-79
613
Parameters controlled by MIDI
CCs #70-79
In Program mode, when CC#70–79 is received on the global
MIDI channel, or when a Realtime Control Slider 1–4 is
operated in Realtime Control Slider 5–8 when the function is
assigned to CC#70–79, the corresponding Program
parameter(s) will be edited temporarily.
In most cases, you can use the Write Program menu
command to save the edited values, over-writing the
previous Program settings.
In Sampling mode, these CCs will temporarily edit the
Program parameters, just as in Program mode. You can use
Convert MS to Program menu command to save that state
as a program (except for some parameters).
In Combination and Sequencer modes, you can use
these CCs to temporarily edit the parameters for all
Timbres or Tracks on a given MIDI channel. However,
edits made in this way cannot be saved back into a
Program.
CC#Internal parameters controlled by the CC
70 (Sustain level)
Filter EG 1/2 Sustain (see page 54)
Amp EG 1/2 Sustain (see page 62)
71 (Filter resonance) Filter A/B, 1/2 Resonance (see page 48)
72 (Release time)
Filter EG 1/2 Release (see page 54)
Amp EG 1/2 Release (see page 62)
73 (Attack time)
EG Times:
Filter EG 1/2 Attack (see page 54)
Amp EG 1/2 Attack (see page 62)
Amp EG 1/2 Time Modulation: Attack (see page 63)
EG Levels:
Amp EG 1/2 Level Start (see page 62)
Amp EG 1/2 Level Attack (see page 62)
Amp EG 1/2 Level Modulation: Start (see page 63)
74 (Filter cutoff frequency) Filter A/B, 1/2 Frequency (see page 48)
75 (Decay time)
Filter EG 1/2 Decay (see page 55)
Filter EG 1/2 Slope (see page 55)
Amp EG 1/2 Decay (see page 62)
Amp EG 1/2 Slope (see page 62)
76 (LFO1 speed) LFO 1 Frequency (see page 66)
77 (LFO1 Pitch intensity) Pitch LFO1 Intensity (see page 41)
78 (LFO1 delay) LFO 1 Delay (see page 67)
79 (Filter EG intensity)
Filter EG 1/2 Intensity to A (see page 52)
Filter EG 1/2 Intensity to B (see page 52)
To Next Page
Loading...
Need help?
General
