Sampling P9: MFX/TFX 9–1: Routing
327
Sampling P9: MFX/TFX
Here you can select the effect types for the master effects
and total effect, and turn them on/off.
The master effects are output to the L/R bus. The total effect
is inserted in the L/R bus. If you want to use these while
sampling, set Source Bus to L/R.
For more information, please see the “Effect Guide,”
beginning on page 421.
Note: When you sample, MFX1 On/Off, MFX2 On/Off, TFX
On/Off are automatically turned off. This is done so that the
effect will not be applied again (i.e., a second time) when
you play back the sample that was resampled with the
MFX1/2 and TFX. (In the same way, the Bus Select (All
OSCs to) parameter will automatically be set to L/R.) Be
aware of this if you want to sample once again.
9–1: Routing
These parameters are the same as in Program mode.
For more information, please see “9–1: Routing” on
page 103.
9–1a: MFX
MFX1:
MFX1 [000...170]
MFX1 On/Off [Off, On]
Return 1 [000...127]
MFX2:
MFX2 [000...153]
MFX2 On/Off [Off, On]
Return 2 [000...127]
Chain:
Chain On/Off [Off, On]
Chain Direction [MFX1→MFX2, MFX2→MFX1]
Chain Level [000...127]
For more information, please see “9–2: MFX1” on page 104.
9–1c: TFX
TFX:
TFX [000...153]
TFX On/Off [Off, On]
For more information, please see “9–4: TFX” on page 105.
9–1d: Master Volume
Master Volume [000...127]
For more information, please see “9–1c: Master Volume” on
page 104.
▼9–1: Menu Command
• 0: Panel–SW Solo Mode On ☞p.329
• 1: Exclusive Solo ☞p.329
• 2: Copy MFX/TFX ☞p.352
• 3: Swap MFX/TFX ☞p.353
For more information, please see “Sampling: Menu
Command” on page 329.
9–1a
9–1c
9–1d
9–1c
9–1b
9–1
Menu
To Next Page
Loading...
