COMBI P3: Timbre Param (Timbre Parameters) 3–1: MIDI T01–08, 3–2: MIDI T09–16
149
COMBI P3: Timbre Param (Timbre Parameters)
3–1: MIDI T01–08,
3–2: MIDI T09–16
Here you can make MIDI settings for timbres 1–8 and 9–16.
3–1(2)a: Combination Name, Tempo
3–1(2)b:Timbre Info
For more information, please see “2–1: EQ Trim T01–08, 2–2:
EQ Trim T09–16” on page 147.
3–1(2)c: MIDI
Timbre 01 (Timbre Number):
Status [Off, INT, EXT, EX2]
This sets whether the Timbre controls the internal sounds, or
external MIDI devices.
When controlling external MIDI devices, it also allows you
to choose between using the internal Bank Select numbers
(as set by the front-panel switches), or using custom Bank
Select settings to match the external device.
Off: Use this to disable the Timbre. With this setting, the
Timbre’s Program will not sound, and MIDI data will not be
transmitted.
INT: When you operate the KYBD-61/73/88 or a controller,
the timbre will sound, and will also sound in response to
MIDI messages from an external MIDI device. MIDI data
will not be transmitted.
EXT: The timbre will not sound even if it receives messages
from the KYBD-61/73/88 or a controller, but MIDI data will
be transmitted to external devices.
EX2: Use this to play an external MIDI device, with custom-
set Bank Select via the Bank Select (When Status=EX2)
LSB and MSB parameters, on the MIDI tab of the Timbre
Parameters page. In all other ways, this is the same as EXT.
MIDI Channel [01...16, Gch]
Sets the MIDI transmit/receive channel for each timbre.
Gch: The timbre will use the channel that has been selected
as the global MIDI Channel (Global 1–1a).
When Status is INT, MIDI messages will be received on the
channel you specify here. If this setting is the same as the
global MIDI channel, the internal tone generator will sound
according to the internal settings. If this is set to EXT or EX2,
playing the M3 will transmit MIDI messages on the MIDI
channel specified here. (Messages will also be transmitted
simultaneously on the global MIDI channel.)
Bank Select (When Status = EX2) MSB [000...127]
Bank Select (When Status = EX2) LSB [000...127]
Specifies the bank number that will be transmitted when
Status is set to EX2. The upper line is the MSB, and the
lower line is the LSB. This setting has no effect if Status is
other than EX2.
Timbre 02...08, 09...16 (Timbre Number):
These are the MIDI-related settings for timbres 2–8 and 9–16.
They are the same as for timbre 1. For more information,
please see “Timbre 01 (Timbre Number):,” above.
▼3–1(2): Menu Command
• 0: Write Combination ☞p.185
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy from Program ☞p.185
For more information, please see “Combination: Menu
Command” on page 185.
3–1a
3–1c
3–1b
3–1
Menu
MIDI IN/
USB B
INT
MIDI OUT/
USB B
EXT, EX2
Tone
generator
To Next Page
Loading...
Need help?
General
