Sequencer mode
258
▼8–1–1(2): Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy Insert Effect ☞p.117
• 4: Swap Scene ☞p.115
• 5: DrumKit IFX Patch ☞p.190
• 6: FF/REW Speed ☞p.272
• 7: Set Location (Set Location for Locate Key) ☞p.272
• 8: Put Effect Setting to Track ☞p.288
For more information, please see “Sequencer: Menu
Command” on page 271.
8–1–3: Insert FX Setup
8–1–3a: Track Select
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 224.
8–1–3b: Insert Effect
Here you can choose the type of each insert effect 1 through
5, its on/off status, chaining, and adjust the post-IFX mixer
settings. For insert effects, the direct sound (Dry) is always
stereo-in and out. The input/output configuration of the
effect sound (Wet) depends on the effect type. For
descriptions of the individual effects, please see “Effect
Guide,” beginning on page 421.
The following parameters are the same as in Program mode.
For more information, please see “8–2: Insert FX Setup” on
page 99.
However, unlike in Program mode, insert effect dynamic
modulation (Dmod) and the post-IFX Pan: #8, Send 1, and
Send 2 are controlled on the MIDI channel specified by Ch
(Seq 8–1–4(5)(6)(7)(8)a). The control changes used are the
same as in Program mode.
The pan (CC#8), send 1 and 2 settings you make here will be
used when the song is played or recorded from the
beginning. If you change the settings while recording a
MIDI track, the changes will be recorded as part of the
musical data, and the settings will change when the data is
played back. You can also change these settings during
playback. However if pan (CC#8), send 1, or 2 data has been
recorded, the settings will change accordingly.
If Status (Seq 3–1(2)c) is either INT or BTH, CC#8,
CC#93, and CC#91 can be received to control the pan
following the insert effect, send 1, or send 2
respectively, and change their settings. When you
switch songs or return to the beginning of the song,
tracks whose Status is BTH, EXT, or EX2 will transmit
these settings via MIDI. This data will be transmitted
on the MIDI channels specified in the IFX 1–5 pages
(Seq 8–1–4(5)(6)(7)(8)a).
8–1
–3b
8–1
–3a
8–1
–3
Menu
To Next Page
Loading...
Need help?
General
