Korg M3 - 0-1-5: Playloop T01-08, 0-1-6: Playloop; T09-16

Sequencer mode
200
▼0–1–3(4): Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Rename Song ☞p.271
• 4: Delete Song ☞p.271
• 5: Copy From Song ☞p.271
• 6: Load Template Song ☞p.271
• 7: Save Template Song (Save as User Template
Song) ☞p.272
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: GM Initialize ☞p.273
• 11: Copy From Combi (Copy from
Combination) ☞p.273
• 12: Copy from Program ☞p.273
• 13: Copy X–Y Motion ☞p.107
For more information, please see “Sequencer: Menu
Command” on page 271.
0–1–5: PlayLoop T01–08,
0–1–6: PlayLoop T09–16
When playing or recording a song, you can independently
loop the MIDI tracks.
0–1–5(6)a: Location, Meter, Tempo,
Tempo Mode, Song Select,
Track Select, Reso, RPPR
For more information, please see “0–1–1: Program T01–08,
0–1–2: Program T09–16” on page 195.
0–1–5(6)b: Play Loop
Selected Track Info
This displays information about the currently selected MIDI
track. For more information, please see “0–1–1(2)b: Track
Program Select” on page 197.
Track 01 (Track Number):
Category [Category Name]
Indicates the category.
Track Play Loop [Off, On]
Specifies looping for a MIDI track.
On (checked): That track will loop between Loop Start
Measure and Loop End Measure.
Loop Start Measure [001...999]
Specifies the first measure of the loop.
Loop End Measure [001...999]
Specifies the last measure of the loop.
Play Intro [Off, On]
On (checked): After the measures before the specified Loop
Start Measure are played once, the region of Loop Start
Measure – Loop End Measure will be played repeatedly.
For example, you can use this on a drum track to make it
play a fill-in and then begin looping.
Off (unchecked): Playback will begin from the Loop Start
Measure, and will begin looping immediately.
This will be valid if Track Play Loop is checked and
Loop Start Measure is set to other than 001.
0–1
–5b
0–1
–5a
0–1
–5
Menu