Korg M3 - 7-3-5: Ge Rtp a; 7-3-6: Ge Rtp B, 7-3-7: Ge Rtp C, 7-3-8: Ge Rtp D

SEQ P7–3: KARMA 3 7–3–5: GE RTP A (GE Real-Time Parameters A)
253
7–3–5: GE RTP A
(GE Real-Time Parameters A)
In KARMA Module A, you can control the GE realtime
parameters independently specified for the KARMA
module.
7–3–5a: GE No. & Name, GE RTC Select,
Tempo
GE Number & Name
GE RTC Select [1–8, 9–16, 17–24, 25–32]
 (Tempo) [040.00...300.00, EXT]
For more information, please see “7–2–1a: GE Number &
Name, GE RTC Select, Tempo” on page 90.
7–3–5b: GE Real-Time Parameters for
Module Control = A, B, C, D
GE RTParm 01…32:
GE PARAM (GE Real-time Parameter)
MIN (GE Real-time Parameter Minimum Value)
[–5000…+5000]
MAX (GE Real-time Parameter Maximum Value)
[–5000…+5000]
VALUE (GE Real-time Parameter Value)
[–5000…+5000]
ASSIGN (GE Real-time Parameter Assign)
[---, SL1…8, SL1s…8s, SW1…8, Dyn1…8]
POL (GE Real-time Parameter Polarity) [+, –]
For more information, please see “7–2–1b: GE Real-Time
Parameters” on page 90 and “7–3–1b: GE Real-Time
Parameters for Module Control = Master” on page 252.
▼7–3–5: Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: Copy from Program ☞p.185
For more information, please see “Sequencer: Menu
Command” on page 271.
7–3–6: GE RTP B,
7–3–7: GE RTP C,
7–3–8: GE RTP D
(GE Real-Time Parameters B, C, D)
In each KARMA modules B, C, and D, you can control the
GE realtime parameters independently specified for the
KARMA module.
For more information, please see “7–3–5: GE RTP A (GE
Real-Time Parameters A),” above.
7–3
–5a
7–3
–5b
7–3
–5
Menu