Sequencer mode
254
SEQ P7–4: KARMA 4
7–4–1: Perf RTP
(Perf Real-Time Parameters)
Here you can assign controllers to KARMA Performance
Real-Time Parameters (Perf. RTP) outside of the GE Real-
Time Parameters that control the internal settings of the GE.
By assigning these to KARMA Sliders 1–8 and KARMA
Switches 1–8 etc., you can control them in real-time while
you play.
Parameters selected in Group and Param (Global 7–4–
1b) and for which A/B/C/D is turned on cannot be
edited in pages such as the KARMA key zone
parameter or KARMA module parameter pages.
7–4–1a: Track Select, Tempo, RPPR
For more information, please see “2–1: Trim T01–08, 2–2:
Trim T09–16” on page 224.
7–4–1b: Perf Real-Time Parameters
Select (Perf RTP Select) [1–2, 3–4, 5–6, 7–8]
Perf Real-Time Parameters
Group [Off, PE, Mix, Control, Trigger, Key Zones,
Random Seeds]
Param (Parameter)
[---, Time Signature... Retrigger Each Time]
Min (Min Value) [–8192…+8191]
Max (Max Value) [–8192…+8191]
Value [–8192…+8191]
A/B/C/D [Off, On]
Assign [---, SL1…8, SL1s…8s, SW1…8, Dyn1…8]
Polarity [+, –]
For more information, please see “7–4–1b: Perf Real-Time
Parameters” on page 173.
▼7–4–1: Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: Copy from Program ☞p.185
For more information, please see “Sequencer: Menu
Command” on page 271.
7–4
–1a
7–4
–1b
7–4
–1
Menu
To Next Page
Loading...
