Reverb and Early Reflections (Reverb ER)
487
Changing these parameter values allows you to simulate the
type of walls in the room. That is, a larger ER Level
simulates a hard wall, and a larger Reverb Level simulates a
soft wall.
076: Early Reflections
This effect is only the early reflection part of a reverberation
sound, and adds presence to the sound. You can select one
of the four decay curves.
a: Type
This parameter selects the decay curve for the early
reflection.
aType
Sharp, Loose,
Modulated,
Reverse
Selects the decay curve for the
early reflection p.487
b
ER Time
[msec]
10...800
Sets the time length of early
reflection
c
Pre Delay
[msec]
0...200
Sets the time taken from the
original sound to the first early
reflection
d EQ Trim 0...100
Sets the input level of EQ
applied to the effect sound
e
Pre LEQ Fc
Low,
Mid-Low
Selects the cutoff frequency
(low or mid-low) of the low-
range equalizer
Pre HEQ Fc
High,
Mid-High
Selects the cutoff frequency
(high or mid-high) of the high-
range equalizer
f
Pre LEQ Gain
[dB]
–15.0...+15.0 Sets the gain of the Low EQ
Pre HEQ Gain
[dB]
–15.0...+15.0 Sets the gain of the High EQ
g
Wet/Dry
Dry, 1 : 99...
99 : 1, Wet
Sets the balance between the
effect and the dry input
Src Off...Tempo
Selects a modulation source for
Wet/Dry
Amt –100...+100
Sets the modulation amount
for Wet/Dry
Reverb - Room Type
Time
Level
Louder
ER
(Early Reflections)
Dry
Reverb
Pre Delay Thru
Pre Delay
Reverb Time
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
EQ Trim
+
EQ Trim
Pre Delay
Early Reflections
LEQ HEQ
Sharp
Loose
Modulated
Early Reflections - Type
Reverse
Dry
Pre Delay
ER Time
To Next Page
Loading...
Need help?
General
