Korg M3 - Seq P7-2: Karma 2; 7-2-1: Control a; 7-2-2: Control B, 7-2-3: Control C; 7-2-4: Control D

Sequencer mode
250
SEQ P7–2: KARMA 2
7–2–1: Control A
Here you can set KARMA Module Control parameters. In
Combination mode, four KARMA Module A can be used.
For more information, please see “7–2–1: Control A” on
page 169.
7–2–1a: Module Parameter-Control
Control:
Transpose [–36…+36]
Root Position [Off, On]
Force Range
[Off, Lowest, Highest, C3-B3[1], C3-B3[2]]
Force Range Wrap [C…B]
For more information, please see “Control:” on page 84.
Timber Zone Bypass [Off, On]
For more information, please see “Timbre Zone Bypass” on
page 169.
Clock Advance:
Mode [Auto, Dyn, Auto+Dyn1, Auto+Dyn2]
Chord Trigger Mode
[Off, 1st, Chord1, Chord2, Chord3]
Size [
3, 3, , 3, , , 3, , , 3, , Event]
Velocity Sense Bottom [001…127]
For more information, please see “Clock Advance:” on
page 85.
Note Map:
Mode (Note Map Mode)
[Off, On-Main, On-Repeat, On-All]
Table (Note Map Table)
[Custom, Gtable 1…Gtable 64]
Transpose (Note Map Transpose) [–12…+12]
Chord Track (Note Map Chord Track) [Off, On]
Keyboard Track (C2 Ref)
(Note Map Keyboard Track) [Off, On]
Note Map Display
For more information, please see “Note Map:” on page 86.
▼7–2–1: Menu Command
• 0: Memory Status ☞p.271
• 1: Panel–SW Solo Mode On ☞p.106
• 2: Exclusive Solo ☞p.107
• 3: Copy KARMA Module ☞p.114
• 4: Initialize KARMA Module ☞p.115
• 5: Copy Scene ☞p.115
• 6: Swap Scene ☞p.115
• 7: Capture Random Seed ☞p.116
• 8: FF/REW Speed ☞p.272
• 9: Set Location (Set Location for Locate Key) ☞p.272
• 10: Copy from Program ☞p.185
For more information, please see “Sequencer: Menu
Command” on page 271.
7–2–2: Control B,
7–2–3: Control C,
7–2–4: Control D
In these pages you can set the parameters (controls) for
KARMA modules B, C, and D.
For more information, please see “7–2–1: Control A,” above.
7–2
–1a
7–2
–1
Menu